UC type bearing is self-aligning for standard load capacity. Has dual set screw locking, wide inner ring, metal slingers with contact seals and anti-rotation device. Standard relubrication feature has a drilled hole in groove on the set screw side of bearing.

Extended Race Bearing

Used with Weldasprockets® & Weldapulleys®

We carry both A, B and C V-Belts.

WELDASPROCKETS® for Roller Chain.  Order No. indicates chain size, number of teeth and hub series required. Example: 3515V = 35 Chain, 15 Teeth, V series hub required. See WELDAHUBS® for the different hub series we have available.

For chain A550 & A620 (Implement Roller Chain).

A Wire Rope Clip is used to clamp the loose end of wire rope after it has been looped back to form an eye.  These wire rope fittings consist of a u-bolt and has a saddle that is secured by two nuts.  Wire rope assemblies generally need at least 2 or 3 wire rope clips to properly secure the wire rope ends to the length of the rope.

When the wire rope terminations create the eye, there is a risk that the eye will bend too much, especially with a heavy load.  Adding a wire rope thimble (sold in this section) to the eye can help lengthen the service life of the rope by adding a layer of protection to the rope.

Choosing the correct type of wire rope is also important when using a wire rope clip.  Saftey Note:  wire rope clips should not be used on plastic-coated cable, unless the plastic is first stripped off.  Install wire rope clips over bare cable only.  Nuts on wire rope clips should be re-tightened/re-torqued regularly.

Wire Rope Thimbles are used in wire rope assemblies to keep an eye from being crushed.  When a wire rope assembly is terminated with an eye or loop at the end, a cable thimble is inserted to form the eye of the loop before the rope is secured.  Steel thimbles, or stainless steel thimbles in high corrosive enviroments, offer added protection from wear and tear of direct contact and deformation of the eye.  By adding this protection, it lenghtens the service life of your wire rope or wire rope slings.  Breaking strength is typically not denoted on steel rope thimbles as the pressure on the thimble eye can very depending on tension and direction the pressure comes from.

Alloy is the only chain recommended for overhead lifting and other applications where the hightest strength to weight ratio is required. IT IS THE ONLY CHAIN APPROVED BY OSHA FOR OVERHEAD LIFTING. Hook ends are also available - see Hardware Chain Accessories.

High Test. Easier handling without sacrificing desired safe working load limits. IT IS NOT TO BE USED FOR OVERHEAD LIFTING. Hook ends are also available - see Hardware Chain Accessories.

Proof Coil is an excellent general purpose chain for applications where there is little need for a high strength to weight ratio. It can be found in tow chains, logging chains and in binding applications. IT IS NOT TO BE USED FOR OVERHEAD LIFTING. Hook ends are also available - see Hardware Chain Accessories.

Straight Link Coil chain is a welded chain easily identified by its link design. The link is long and relatively narrow in proportion. It is an excellent choice for tailgates, trailer safety chain, and barrier chain. IT IS NOT TO BE USED FOR OVERHEAD LIFTING.

Straight Link Machine chain is a welded chain noted for it's flexibility. Used for overhead doors, tailgates and agricultural implements. IT IS NOT TO BE USED FOR OVERHEAD LIFTING.

Transport Chain is considered the chain of choice for load binding application. It is also well suited for tie-downs, exceeds that of Proof Coil and High Test. Transport Chain P-70 meets Department of Transportation regulations. IT IS NOT TO BE USED FOR OVERHEAD LIFTING. Hook ends are also available - see Hardware Chain Accessories.

A modification of Straight Link Machine chain which allows the chain to lay flatter. Working load limit is slightly less than Straight Link Machine chain. IT IS NOT TO BE USED FOR OVERHEAD LIFTING.